Pro 5.0 shifter install

OK, the oil senser that I am going to tee off of, is that the one that is attatched to the oil filter housing. If so then I can probably have this done by sat. Do you remember what wires you used to attatch the white and red one to and did you fuse the 12v one. Mine are electric. I have everything else that we need for the rear brakes to. Just let me know what day this weekend works for you. I will have it jacked up and the rear tires off and ready for what ever day we choose. Thanks alot. By the way what kind of beer do you drink Will? Want to have some coldies ready for when we are done.

one more dumb question but better ask. Do i have to drain the oil in order to install the T and sensors back in?

It will weep a little out of the sensor hole. Preferably you will undo it and let it weep for about 20 min. If there is synthetic on the threads it will eat through the teflon tape. I usually clean everything with a spray of brake clean. then blot it dry before I screw it in with teflon tape.

I hooked pretty much all of my guages into the light switch and dimmer module. Then I can dim everything and works all with the interior lights switch.

Teh light switch just pops out and I followed them down a little till it hits the kick panel.

Hope this helps

BJ, I will be riding up in PA on Saturday. Lets plan for Sunday for the brake install.

Will

Sounds good. So the sensor on the side of the oil filter is the one that I want to replace with the tee correct? Does anyone remember what wires on the factory harness are the correct ones for the 12v swithch then the light wire

Here ya go bro...

http://iihs.net/fsm/?dir=40

Which diagram do i go off? and if you dont mind can you tell me what color the wires are supposed to be. I dont know how to read these. If you can do that I will be able to install all of this and sunday we will be able to just do the brakes. I really appreciate all of this as well.