Maryland Patriot Stangs & Fords
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Possible engine tapping

4 posters

Page 2 of 2 Previous  1, 2

Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by mjr46 Sun Sep 14, 2014 10:08 pm

nicholasa631 wrote:Reverse only started this morning on a cold start up.
a growl?? is the fluid level full??

mjr46
BOSS
BOSS

Number of posts : 649
Age : 49
Location : Maryland
Registration date : 2008-02-16

Back to top Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by nicholasa631 Mon Sep 15, 2014 12:55 am

Will double check it. It was strange because it only had happened when I was backing out of my garage hasn't happened again, but will give it a good checking in the morning
nicholasa631
nicholasa631
MACH 1
MACH 1

Number of posts : 275
Age : 40
Location : Olney, MD
Registration date : 2013-05-22

Back to top Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by nicholasa631 Tue Sep 16, 2014 11:41 pm

So spoke with a few more people and turns out that one possibility is a normal noise with the AC on, another possibility is the new throw out bearing is bad. Time will tell, and going to change the rear diff oil and see if that stops the rear end issue
nicholasa631
nicholasa631
MACH 1
MACH 1

Number of posts : 275
Age : 40
Location : Olney, MD
Registration date : 2013-05-22

Back to top Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by mjr46 Tue Sep 16, 2014 11:57 pm

nicholasa631 wrote:So spoke with a few more people and turns out that one possibility is a normal noise with the AC on, another possibility is the new throw out bearing is bad. Time will tell, and going to change the rear diff oil and see if that stops the rear end issue
I doubt that new throwout is bad.........could be an issue with input shaft bearing in the tranny as it'll stop spinning with the clutch pressed in, but I wouldn't be overly concerned as long as noise doesn't get any louder and the next time you come up for something such as gears, I can go for a ride and give you my opinion.  Also if you plan to do gears within the near future you can kill a few birds with that stone such as swapping out fluid and save on money there.

mjr46
BOSS
BOSS

Number of posts : 649
Age : 49
Location : Maryland
Registration date : 2008-02-16

Back to top Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by nicholasa631 Wed Sep 17, 2014 7:24 am

very true, will let you know
nicholasa631
nicholasa631
MACH 1
MACH 1

Number of posts : 275
Age : 40
Location : Olney, MD
Registration date : 2013-05-22

Back to top Go down

Possible engine tapping  - Page 2 Empty Re: Possible engine tapping

Post by Sponsored content


Sponsored content


Back to top Go down

Page 2 of 2 Previous  1, 2

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum